Step 1540-11
The system is working correctly with this configuration. One of the FRUs (adapters)
that you removed is probably defective,
1. Turn the power off.
2. Install a FRU (adapter) and connect any cables and devices that were attached
to it.
3. Turn the power on.
4. Insert the diagnostic CD-ROM disc into the CD-ROM drive.
5. After the POST indicators are displayed and before the long beep press the F5
key on a direct attached keyboard or the number 5 key on a ASCII terminal
keyboard.
6. Wait until the "Please define the System Console" screen is displayed or the
system appears to stop.
Is the "Please define the System Console" screen displayed?
NO Go to “Step 1540-12” on page 2-29.
YES Repeat this step until all of the FRUs (adapters) are installed. If you have
exchanged all of the FRUs (adapters) and the sympton did not change,
go to MAP 0020 in the
IBM RS/6000 Diagnostic Information for Multiple
Bus Systems
.
2-28 Service Guide
To Next Page
Loading...
