Step 1540-16
One of the adapters or devices you removed is causing the problem.
Install the adapters and devices one at a time to determine the failing adapter or
device. If the adapter you are installing is an ISA adapter, go to the Service Aids to
configure it. If the adapter or device you are installing (ISA or PCI) will not configure
or causes the system to stop, replace the adapter or device. Test each adapter or
device after installing it.
Repeat this step until all the adapters and devices you removed are installed.
Go to "MAP 0410: Repair Checkout" in the
IBM RS/6000 Diagnostic Information for
Multiple Bus Systems
.
If the symptom did not change and all the FRUs have been exchanged, call your
service support person for assistance.
2-32 Service Guide
To Next Page
Loading...
