Highlight the device which the system will search for first when booting, and press
the Spacebar. Notice that numbers appear over the objects, indicating the order of
the startup sequence. Up to four devices can be specified. To cancel your
selection, select the Cancel object. The Default object sets the sequence to:
Diskette drive
CD-ROM drive
Hard disk drive
Tape drive
Network (if installed)
If your system has more devices than shown in the list, their objects will be displayed
after those in the default sequence.
Attention: If you change your custom boot list, you must be extremely careful when
doing
write
operations (for example, saving or formatting). You can accidentally
overwrite data or programs if you select the wrong drive.
Test
Selecting this object enables you to test the memory in your system unit.
Chapter 5. System Management Services 5-5
To Next Page
Loading...
