Enter Password
Press Enter when you are finished; you must type the password again for
verification.
Verify Password
If you make a mistake, press the Esc key and start again.
After you have entered and verified the password, the power-on password status
icon flashes and changes to the locked position to indicate that the power-on
password is installed.
If you previously had set a power-on password and want to remove it, select the
Remove icon.
Note: The system unit power cable must be disconnected before removing the
battery.
A password becomes effective only after the system is turned off and back on again.
Chapter 6. System Management Services 6-11
To Next Page
Loading...
