Set Address
The Set Address icon allows you to define addresses from which your system unit
can receive RIPL code.
Client Addr
Remote IPL Setup
Exit
000.000.000.000
000.000.000.000
000.000.000.000
000.000.000.000
Gateway Addr
Server Addr
Subnet Mask
Save
If any of the addresses is incomplete or contains a number other than 0 to 255, an
error message is displayed when you select the Save icon. To clear this error,
change the improper address and select Save again.
Chapter 6. System Management Services 6-17
To Next Page
Loading...
