Processor Card
Removal of Processor Card
Attention: Installing a new processor card into your system unit may require
updating the firmware. A diskette or CD-ROM is included with your new
processor card if that is required.
1. If you have not already done so, shutdown the system as described in “Stopping
the System Unit” on page 7-4.
2. If you have not already done so, unplug the system unit power cable from the
electrical outlet.
3. If you have not already done so, remove the front, rear, and left side covers
described in “Removal of Covers” on page 7-5.
4. Remove the processor and memory card cover as described in “Removal of
Processor and Memory Card Cover” on page 7-10.
5. The processor card is secured in place with card retainer latches, one on each
end of the card. Open the card retainer latches and remove the card from the
connector.
Attention: To prevent damage to the card and the card connectors, open and
close the retainer latches at the same time.
Chapter 7. Removal and Replacement Procedures 7-17
To Next Page
Loading...
