Replacement of Adapters
1. If you are not installing another adapter in this slot location, replace the
expansion slot cover. Slide the cover over the expansion slot and tighten the
screw on the top of the expansion slot cover.
2. Carefully grasp the adapter by the edges and align the adapter with the
expansion-slot connector.
3. Press the adapter firmly into the expansion-slot connector.
4. Use the screw you removed earlier from the expansion-slot cover to secure the
adapter card bracket to the system unit.
5. Connect any cables you removed earlier to the adapter.
6. Replace the system unit covers as described in “Replacement of Covers” on
page 7-9.
Chapter 7. Removal and Replacement Procedures 7-21
To Next Page
Loading...
