4. Use one finger to slightly slide the battery toward the front of the server. (The
spring mechanism behind the battery pushes it out toward you as you slide it
forward.) Use your thumb and index finger to hold the battery as it pushes out of
the socket.
Replacement of Battery
1. Tilt the battery so that you can insert it into the front of the socket. As you slide
the battery toward the front of the server, push it down into the socket.
Note: Be sure to tell the customer that the time and date need to be reset.
If running AIX the bootlist command may have to be run from AIX while
logged in as root, this would restore the custom boot list and allow the
option of Select Software under multiboot to start the operating system.
Other parameters that may have to be rebuilt are the IP parameters.
Ensure that the battery polarity is correct; place the battery in the holder
with the positive side facing up.
2. Replace the processor and memory card cover.
3. Replace the system unit covers as described in “Replacement of Covers” on
page 7-9.
Chapter 7. Removal and Replacement Procedures 7-29
To Next Page
Loading...
