Step 1540-5
No failure was detected with this configuration.
1. Turn the power off and remove the power cable.
2. Install a pair of memory modules.
3. Plug in the power cable (and wait for OK on the operator panel display).
4. Turn the power on.
Does the system stop with code E1F2, E1F3, STBY or 4BA00830 displayed on
the operator panel?
NO Go to “Step 1540-6” on page 2-38.
YES Repeat this step until all the memory modules are installed and tested.
After all the memory modules are installed and tested, record the
positions of the memory modules in the second memory card. Remove
all of the memory modules from the second memory card except 1 pair.
Repeat this step with the second memory card (if previously installed).
Go to “Step 1540-9” on page 2-41.
Chapter 2. Maintenance Analysis Procedures 2-37
To Next Page
Loading...
