Step 1540-9
1. Turn the power off.
2. Reconnect the system console.
Notes:
a. If an ASCII terminal has been defined as the system console, attach the
ASCII terminal cable to the to the S1 connector on the rear of the system
unit.
b. If a display attached to a display adapter has been defined as the system
console, install the display adapter and connect the display to it. Plug the
keyboard into the keyboard connector on the rear of the system unit.
3. Turn the power on.
4. If the ASCII terminal or graphics display (including display adapter) are
connected differently than before, the Console Selection screen appears and
requires that a new console be selected.
5. When the keyboard indicator is displayed, press the F1 key on the directly
attached keyboard or the number 1 key on an ASCII terminal. This triggers the
SMS.
6. Enter the appropriate password if prompted to do so.
Chapter 2. Maintenance Analysis Procedures 2-41
To Next Page
Loading...
