Step 1540-11
The system is working correctly with this configuration. One of the SCSI devices that
you disconnected may be defective.
1. Make sure the diagnostic CD-ROM is inserted into the CD-ROM drive.
2. Turn the power off and remove the power cable.
3. Connect the signal and power connectors to one of the SCSI devices (CD-ROM
drive, tape drive, disk drive, etc.). Do not connect the signal and power
connectors to the backplane at this time.
4. Plug in the power cable (and wait for OK on the operator panel display).
5. Turn the power on.
6. After the keyboard indicator is displayed, press the F5 key on the
directly-attached keyboard or the number 5 key on an ASCII terminal keyboard.
7. Enter the appropriate password if prompted to do so.
2-44 Service Guide
To Next Page
Loading...
