Step 1540-24
1. Ensure that the diagnostics and the operating system are shut down.
2. Turn the power off.
3. If you have not already done so, configure the Service Processor with the
instructions from note six in “MAP 1540: Minimum Configuration” on page 2-31
and then return here and continue.
4. Exit Service Processor Menus and remove the power cable.
5. Remove the side cover.
6. Record the slot numbers of the PCI adapters. Label and record the location of
any cables attached to the adapters. Disconnect any cables attached to the
adapters and remove all the adapters.
7. Plug the power cable into a power outlet (and wait for OK on the operator panel
display).
8. Turn the power on.
Does the system stop with the same error code displayed on the operator
panel that directed you to this MAP step?
NO Go to “Step 1540-26” on page 2-58.
YES Go to “Step 1540-25” on page 2-57.
2-56 Service Guide
To Next Page
Loading...
