Step 1540-26
The system is working correctly with this configuration. One of the FRUs (adapters)
that you removed is probably defective.
1. Turn the power off and remove the power cable from the power outlet.
2. Install a FRU (adapter) and connect any cables and devices that were attached
to it.
3. Plug in the power cable (and wait for OK on the operator panel display).
4. Turn the power on.
5. If the Console Selection screen displays, choose the system console.
6. Enter the appropriate password if prompted to do so.
Does the system stop with the same error code displayed on the operator
panel that directed you to this MAP step?
NO Repeat this step until all of the FRUs (adapters) are installed, then go to
"MAP 410: Repair Checkout" in the
IBM RS/6000 Diagnostic Information
for Multiple Bus Systems
.
YES Go to “Step 1540-27” on page 2-59.
2-58 Service Guide
To Next Page
Loading...
