Table 3-5 (Page 5 of 10). Firmware Checkpoints.
Checkpoint Description Action/
Possible Failing FRU
E196 Probe ISA bus. See the note on 3-30.
E19B Create Service Processor node. See the note on 3-30.
E19C Create tablet node. See the note on 3-30.
E19D Create nvram node. See the note on 3-30.
E19E Real time clock (RTC) creation and
initialization.
Refer to error code 28030xxx in
“Firmware/POST Error Codes” on
page 3-2.
E19F Create eeprom node. See the note on 3-30.
E1AD See description of checkpoint
E1DE.
See the note on 3-30.
E1B0 Create lpt node. See the note on 3-30.
E1B1 Create serial node. See the note on 3-30.
E1B2 Create audio node. See the note on 3-30.
E1B3 Create 8042 node. See the note on 3-30.
E1B6 Probe for (ISA) keyboard. See the note on 3-30.
E1BA Enable L2 cache. See the note on 3-30.
E1BB Set cache parms for burst. See the note on 3-30.
E1BC Set cache parms for 512KB. See the note on 3-30.
E1BD Probe for (ISA) mouse. See the note on 3-30.
E1BE Create op-panel node. See the note on 3-30.
E1BF Create pwr-mgmt node. See the note on 3-30.
E1C0 Create ISA ethernet node. See the note on 3-30.
E1C5 Create ISA interrupt controller (pic)
node.
See the note on 3-30.
E1C6 Create dma node. See the note on 3-30.
E1D0 Create PCI SCSI node. See the note on 3-30.
E1D3 Create (* wildcard *) SCSI block
device node (SD).
See the note on 3-30.
E1D4 Create (* wildcard *) SCSI byte
device node (ST).
See the note on 3-30.
E1DB Create floppy controller (FDC) node. See the note on 3-30.
Chapter 3. Error Code to FRU Index 3-37
To Next Page
Loading...
