Select Language
This option allows you to change the language used by the text-based System Man-
agement Services screens.
à ð
SELECT LANGUAGE
1. English
2. Francais
3. Deutsch
4. Italiano
5. Espanol
6. Svenska
====> .------.
|x=Exit|
------'
á
ñ
Note: Your ASCII terminal must support the ISO-8859 character set in order to
properly display languages other than English.
Open Firmware Command Prompt
To enter the Open Firmware command line, you must press the F8 key
after the
keyboard icon appears
during startup.
If you have pressed the F8 key, the Open Firmware command line (an "OK" prompt)
appears after the initialization and power-on self test (POST) are complete.
The OK Prompt provides access to the Open Firmware command prompt. The Open
Firmware command prompt is used for debug purposes, and device driver develop-
ment. Information about the commands that are available in the IEEE Standard 1275.
The Open Firmware command line is used to set up adapters that are not
configurable with the System Management Services. Your adapter documentation
directs you to use this option if it is needed.
To exit from the Open Firmware command enter reset-all or power the system
down and reboot.
Chapter 6. System Management Services 6-33
To Next Page
Loading...
