2. Loosen the screws that hold the disk drive cover to the drawer and remove the
the disk drive cover from the drawer, storing it in a safe place.
Attention: Physically removing a hot swap drive from the CPU Drawer before it
has been removed from the system configuration, may cause unrecoverable data
corruption.
3. Verify that the device has been removed from the system configuration; the
yellow LED on the hot swap disk drive should be off.
Attention: Caution should be used when handling all hard drives. Drives are
more likely to be damaged during installation and service. Bumping or handling
drives roughly causes latent failures. Don't stack drives and always use appro-
priate ESD practices. A drop of as little as 1/4 inch can cause latent failures.
Media can take 30 seconds to spin down, so ensure at least a 30 second delay
after switching off the hot-swappable drives for removal.
Chapter 7. Removal and Replacement Procedures 7-11
To Next Page
Loading...
