IBM RS/6000 H50 - Examples; Customizing the Modem Configuration Files

4. Does your modem respond to:
a. AT&F reset command, or
b. AT&Fn reset commands, where n can be 0, 1, etc.?
If AT&F, configuration file modem_f.cfg is recommended.
If AT&Fn, configuration file modem_f0.cfg or modem_f1.cfg is recommended,
depending on which provides the hardware flow control profile.
5. Selection is complete. If you find it necessary to adjust any of these configura-
tion files, do so with reference to the manual that came with your modem.
1
Choose settings that enable hardware flow control and respond to DTR.
Examples
*
Ring interrupt only on first ring.
Customizing the Modem Configuration Files
You can create your own modem configuration file(s) or modify the samples pro-
vided. After you customize your modem configuration files, you MUST access them
via the Configure Remote Maintenance Policy Service Aid rather than from the
Service Processor menus.
Modem Setup Z Setup Z0
(Rare)
Setup F Setup F0 Setup F1
AT&T DataPort 2001
*
X
Bocamodem 1440E X
Hayes Smart Modem 300 X
IBM 5841 X
IBM 5843 X
IBM 7851 X
IBM 7852-010 X
IBM 7855 X
USRobotics
33.6K Sportster
X
Zoom V.32 X
1
Some older modems do not respond to the commands X or &R1. You should edit out these com-
mands from the modem configuration file if yours is such a modem. See your modem manual for more
information.
Appendix C. Modem Configurations
C-3