IBM RS/6000 H50 - Page 322

service processor menus (continued)
supported menu options A-2
system information A-13
system power control A-12
telephone number A-18
service processor setup B-1
service processor setup checklist B-1
service processor test B-1
service provider A-19
service request numbers (SRNs)
description of 5-1
software and microcode errors 5-2
table 5-3
software and microcode errors 5-2
sp checklist B-1
SP checkpoints 3-30
sp installation
checklist B-1
SP operational phases D-1
sp setup B-1
sp test B-1
specifications, system unit 1-8
SRNs (service request numbers) 5-1,
5-2, 5-3
SSA (serial storage architecture)
adapter 5-13
inactive connector 5-14
link
active 5-14
loop
configurations, invalid 5-11
links 5-13
rules 5-15
standalone diagnostics 4-1
start talk mode A-10
Start Up program 6-7
starting
MAPs 2-45
starting system programs 6-1, 6-21
STBY 2-1, 2-27, 2-28, 2-29, 2-30,
2-31, 3-32, D-2
strings, disk drive module 5-14
surveillance
failure A-29
operating system A-29
set parameters A-11
system firmware A-29
Sys Config program 6-4
system administrator A-19
system board
I/O board 7-37
system board locations 1-5
system data flow 1-7
system information menu A-13
system phone number A-20
system POST errors
read A-5, A-14
system power-on methods A-26
system programs 6-1
Start Up 6-7
starting 6-1, 6-21
Sys Config 6-4
Utilities 6-9
system unit locations 1-1
T
table
service request numbers
(SRNs) 5-3
tape drive. 7-45
test, memory 3-43
testing the setup
call-in B-2
call-out B-2
trademarks xviii
X-6
RS/6000 Enterprise Server Model H50 Installation and Service Guide