IBM RS/6000 H50 - Page 64

Step 1540-8
1. Make sure the diagnostic CD-ROM is inserted into the CD-ROM drive.
2. Turn the power off and remove the power cables.
3. Plug the internal SCSI cable into the SCSI connector (J25) on the I/O board.
4. Disconnect the signal and power connectors from all the SCSI devices except
the CD-ROM drive.
5. Reinstall the power cables.
6. Turn the power on.
7. After the keyboard indicator is displayed, press the F5 key on the directly-
attached keyboard or the number 5 key on an ASCII terminal keyboard.
8. Enter the appropriate password when prompted to do so.
2-34
RS/6000 Enterprise Server Model H50 Installation and Service Guide