X'80' Set if the request specifies RTERMID, or if a FORMATTIME
request specifies DATESEP. If set, IC_ADDR9 is meaningful.
X'40' Set if the request specifies QUEUE. If set, IC_ADDRA is
meaningful.
X'20' Set if the request specifies HOURS. If set, IC_ADDRB is
meaningful.
X'10' Set if the request specifies MINUTES. If set, IC_ADDRC is
meaningful.
X'08' Set if the request specifies SECONDS. If set, IC_ADDRD is
meaningful.
X'04' Set if the request specifies USERID. If set, IC_ADDRE is
meaningful.
X'02' Set if the request specifies SYSNET. If set, IC_ADDRF is
meaningful.
X'01' Set if a FORMATTIME request specifies TIMESEP. If set,
IC_ADDR10 is meaningful.
IC_BITS3
One byte not used by interval control.
IC_EIDOPT5
Indicates whether certain keywords were specified on the request.
X'80' ABSTIME was specified on a FORMATTIME or ASKTIME
command.
X'40' YYDDD was specified on a FORMATTIME command.
X'20' YYMMDD was specified on a FORMATTIME command.
X'10' YYDDMM was specified on a FORMATTIME command.
X'08' DDMMYY was specified on a FORMATTIME command.
X'04' MMDDYY was specified on a FORMATTIME command.
X'02' DATE was specified on a FORMATTIME command.
X'01' On a RETRIEVE command, SET (and not INTO) was specified.
On a START command, ATTACH was specified. On a
FORMATTIME command, DATEFORM was specified. You
cannot modify this field in your user exit.
IC_EIDOPT6
Existence bits that indicate whether certain keywords were specified on
the request.
X'80' DATESEP was specified on a FORMATTIME command.
X'40' DAYCOUNT was specified on a FORMATTIME command.
X'20' DAYOFWEEK was specified on a FORMATTIME command, or
HOURS was specified.
X'10' DAYOFMONTH was specified on a FORMATTIME command,
or FMH was specified.
X'08' MONTHOFYEAR was specified on a FORMATTIME command,
or SECONDS was specified.
154 Customization Guide
To Next Page
Loading...
