The task-related user exit program is provided with a parameter list (DFHUEPAR)
by the CICS management module that handles task-related user exits. This
parameter list gives the task-related user exit access to information such as the
addresses and sizes of its own work areas.
The task-related user exit program can be invoked by any of the following:
v An application program
v CICS SPI manager
v CICS syncpoint manager
v CICS task manager
v CICS termination manager
v CICS context management
v The Execution Diagnostic Facility (EDF)
The parameter list serves to distinguish between these various callers, and gives
access to a register save area containing the caller’s registers.
The administration routines contain the EXEC CICS ENABLE and DISABLE
commands that you use to install and withdraw the task-related user exit program.
Application
program
Stub
Task-related user
exit program
Resource
manager
Non-CICS
resource
DFHRMCAL
CICS SPI
manager
CICS
syncpoint
manager
CICS task
manager
CICS
termination
manager
CICS
context
management
EDF
THE ADAPTER
Figure 4. The adapter concept
268 Customization Guide
To Next Page
Loading...
Need help?
General