IBM SC34-6814-04 User Manual

SET_AUTOINSTALL
DFHPGAQX [CALL,]
[CLEAR,]
[IN,
FUNCTION(SET_AUTOINSTALL),
[AUTOINSTALL_CATALOG (ALL|MODIFY|NONE),]
[AUTOINSTALL_EXIT_NAME(name8),]
[AUTOINSTALL_STATE (ACTIVE|INACTIVE),]
[LANGUAGES_AVAILABLE(NO|YES),]]
[OUT,
RESPONSE(name1 | *),
REASON(name1 | *)]
This command is threadsafe.
AUTOINSTALL_CATALOG(ALL|MODIFY|NONE)
specifies the catalog status for autoinstalled program definitions.
ALL All autoinstalled program, map, and partitionset definitions are to be
cataloged.
MODIFY
Autoinstalled program, map, and partitionset definitions are to be
recorded on the CICS global catalog only if they are modified by a SET
PROGRAM command after being autoinstalled.
NONE No autoinstalled program, map, or partitionset definitions are to be
cataloged.
AUTOINSTALL_EXIT_NAME(name8)
specifies the name of the user-replaceable autoinstall control program for
programs, mapsets, and partitionsets.
AUTOINSTALL_STATE(ACTIVE|INACTIVE)
specifies the status of the program autoinstall function.
ACTIVE
Enable autoinstall for programs, mapsets, and partitionsets.
INACTIVE
Disable autoinstall for programs, mapsets, and partitionsets.
LANGUAGES_AVAILABLE(NO|YES)
specifies whether the autoinstall control program can be called. It can only be
called after language establishment.
NO The control program cannot be called.
YES The control program can be called.
RESPONSE and REASON values for SET_AUTOINSTALL:
RESPONSE REASON
OK None
EXCEPTION None
DISASTER None
INVALID INVALID_FUNCTION
KERNERROR None
PURGED None
Chapter 3. The user exit programming interface (XPI) 383

IBM SC34-6814-04 Specifications

General

Brand	IBM
Model	SC34-6814-04
Category	Server
Language	English