v Different TCT from last run. CICS installs the TCT only, and does not apply the
warm keypoint information, effectively making this a cold start for these
devices.
Note: CICS TS for z/OS, Version 4.1 supports only remote TCAM terminals—that
is, the only TCAM terminals you can define are those attached to a remote,
pre-CICS TS 3.1, terminal-owning region by TCAM/DCB.
Distributed transaction resources
CICS retrieves its logname from the recovery manager control record in the global
catalog for use in the “exchange lognames” process with remote systems.
Resynchronization of indoubt units of work takes place after CICS completes
reconnection to remote systems.
See the CICS Recovery and Restart Guide for information about recovery of
distributed units of work.
URIMAP definitions and virtual hosts
Installed URIMAP definitions for CICS Web support are restored from the global
catalog, including their enable status. Virtual hosts, which are created by CICS
using the host names specified in installed URIMAP definitions, are also restored
to their former enabled or disabled state.
Chapter 5. CICS warm restart 59
To Next Page
Loading...
Need help?
General