IBM SC41-5420-04 - Work with TCP;IP Host Table Display

To add an entry to your local host table, type option 10 on the Configure TCP/IP
menu. The Work with TCP/IP Host Table Entries display is shown in Figure 11.
Note: Just as iSeries TCP/IP automatically creates a LOOPBACK interface, it also
automatically adds an entry to your local host table to associate the IP
address 127.0.0.1 with the host names LOOPBACK and LOCALHOST. Type
option 1 (Add) at the input-capable top list entry to show the Add TCP/IP
Host Table Entry display.
Work with TCP/IP Host Table Display
Figure 12 and Figure 13 on page 20 show how the host table looks after you enter
all hosts explicitly known.
Work with TCP/IP Host Table Entries
System: SYSNAM890
Type options, press Enter.
1=Add 2=Change 4=Remove 5=Display 7=Rename
Internet Host
Opt Address Name
_ _______________
_ 127.0.0.1 LOOPBACK
LOCALHOST
Figure 11. Work with TCP/IP Host Table Entries Display
Work with TCP/IP Host Table Entries
System: SYSNAM890
Type options, press Enter.
1=Add 2=Change 4=Remove 5=Display 7=Rename
Internet Host
Opt Address Name
_ _______________
_ 9.4.6.129 ROUTER2
_ 9.4.6.134 HPUX
_ 9.4.6.138 SPARKY
_ 9.4.6.252 MVAX
_ 9.4.73.65 XSYSNAM890
_ 9.4.73.66 XSYSNAM456
_ 9.4.73.129 ESYSNAM890
_ 9.4.73.130 ESYSNAMRS
_ 9.4.73.193 ROUTER1
_ 9.4.73.198 SYSNAMRS
_ 9.4.73.206 ITALY
_ 9.4.73.207 HOLLAND
_ 9.4.73.208 ENGLAND
More...
Figure 12. Work with Host Table Entries, Display 1 of 2
Chapter 1. Configuring TCP/IP 19