15. Press the Blue Locate Button
Note: The blue locate button can be used to activate the identify LED(s) on the FRU(s) being
serviced, even after the system has been put into service position. It is optional to activate the
identify LED(s) at this time. It may be done any time during the procedure as a reminder of which
FRU(s) is being serviced. The capacitor only holds enough of a charge to activate the LED(s) for
around 30 seconds.
a. Press and hold down the button (A) on the Power APSS card to temporarily activate the identify
LED(s) on the FRU(s) being serviced. This LED(s) will remain active while the button is pressed.
b. The locate button on either Power APSS card may be used.
Remove SCM 11
To Next Page
Loading...
