IBM ThinkPad 380 - Page 130

Installing IBM OS/2 Software
Installing IBM OS/2 Warp
Your installation of OS/2 will differ, depending on whether you use
the Dual Boot or the Boot Manager for switching between OS/2 and
DOS/Windows.
Which type are you going to use?
Dual Boot This page.
Boot Manager Go to page 111.
Installing OS/2 Warp with Dual Boot
To install the DOS ThinkPad
Features program:
Page 121.
To install the Windows ThinkPad
Features program:
Page 126.
Install DOS, Windows, and their ThinkPad Features program before
installing OS/2.
To install OS/2:
To install the diskette version of OS/2, refer to the OS/2
documentation; however, pay attention to the following during
installation:
– Remove any supported devices under Multimedia device
support at the System configuration screen.
Choose the following at the System configuration screen:
- Display —VGA.
- PCMCIA —No.
- Multimedia —No.
-
380D
At the System Configuration screen, ensure
that ThinkPad 755CD TEAC CD-40E is selected for the
CD-ROM drive. If not, Select Non-Listed IDE CD-ROM
or IDE CD-ROM for the CD-ROM drive.
After OS/2 has been successfully installed, make sure you
restart the computer.
To use the CD-ROM version of OS/2, go to page 112.
Note:
If you have the OS/2 Warp FixPak
10 (XR0010) or later, install it after
you complete the installation of OS/2.
Follow the instructions in the
README.1ST file in diskette 1 of
that FixPak.
110 IBM ThinkPad 380 or 380D User's Guide