Installing IBM OS/2 Software
Installing OS/2 Warp with the Boot Manager
To install the DOS ThinkPad
Features program:
Page 121.
To install the Windows ThinkPad
Features program:
Page 126.
1.
Install the Boot Manager, referring to the OS/2 documentation.
2.
Install DOS and Windows, and the ThinkPad Features programs
for both DOS and Windows.
3.
Install OS/2:
If you are installing the diskette version, refer to the OS/2
documentation; however, pay attention to the following:
– Remove any supported devices under Multimedia
Device Support at the System Configuration screen.
–
380D
At the System Configuration screen, ensure
that ThinkPad 755CD TEAC CD-40E is selected for the
CD-ROM drive. If not, Select Non-Listed IDE CD-ROM
or IDE CD-ROM for the CD-ROM drive.
After OS/2 has been successfully installed, restart the
computer.
Note:
If you have the OS/2 Warp FixPak
10 (XR0010) or later, install it after
you complete the installation of OS/2.
Follow the instructions in the
README.1ST file in diskette 1 of
that FixPak.
380D
If you are installing the CD-ROM version of OS/2
using the CD-ROM drive, go to page 112.
Chapter 7. Installing Software 111
To Next Page
Loading...
