IBM ThinkPad 380 - Page 132

Installing IBM OS/2 Software
Installing OS/2 Warp Using a Diskette Drive and CD-ROM Drive
1. Ensure that DOS and Windows are installed in the computer.
2. Insert the OS/2 Warp CD-ROM into the CD-ROM drive.
3. Open the DOS command prompt and change the current drive
to the CD-ROM drive.
4. Type CDINST and press Enter.
Make copies of the OS/2 Warp diskettes according to the
instructions on the screen and label the diskettes.
5. Shut down OS/2 and turn off the computer.
6. Insert the OS/2 Warp Installation Diskette into the diskette drive
and turn on the computer.
7. When you are prompted to insert OS/2 Warp Diskette 1, insert it
into the diskette drive and insert the OS/2 Warp CD-ROM into
the CD-ROM drive.
Note:
If you have the OS/2 Warp FixPak
10 (XR0010) or later, install it after
you complete the installation of OS/2.
Follow the instructions in the
README.1ST file in diskette 1 of
that FixPak.
8. Follow the instructions on the screen until the installation is
complete.
Pay attention to the following during installation:
At the System Configuration screen, ensure that ThinkPad
755CD TEAC CD-40E is selected for the CD-ROM Drive. If
not, select Non-Listed IDE CD-ROM or IDE CD-ROM for
the CD-ROM drive.
Remove any supported devices under Multimedia Device
Support at the System Configuration screen.
9. Shut down OS/2 and restart the computer.
112 IBM ThinkPad 380 or 380D User's Guide