IBM ThinkPad 380 - Page 133

Installing IBM OS/2 Software
Installing the CD-ROM Device Driver for OS/2
380D
If you installed a CD-ROM device driver (ThinkPad 755CD TEAC
CD-40E or Non-listed IDE CD-ROM or IDE CD-ROM on the System
Configuration screen) when installing OS/2, you do not need to
install the CD-ROM device driver. Continue with “Installing the
ThinkPad Features Program for OS/2.”
If you have not installed a CD-ROM device driver when installing
OS/2, have the diskettes that came with OS/2; then install the
CD-ROM device driver for OS/2 as follows:
1. Start OS/2.
2. Open OS/2 System; then open System Setup.
3. Select Install/Remove (for version 4.0).
4. Select Selective Install; then click on the CD-ROM Device
Support.
5. If ThinkPad 755CD TEAC CD-40E is present in the list, select
this and click on OK. If not, select Non-Listed IDE CD-ROM or
IDE CD-ROM and click on OK.
6. Click on OK at the System Configuration screen.
7. At the OS/2 Setup and Configuration screen, select Install; then
follow the instructions on the screen.
For information about the software parameter in the CONFIG.SYS
file, refer to the README file in the CD-ROM Diskette.
Installing the ThinkPad Features Program for OS/2
To install the ThinkPad Features program:
1. Start OS/2; then insert the Utility Diskette for OS/2 into the
diskette drive.
2. Install the ThinkPad System Management device driver:
a) Open OS/2 System and then System Setup.
b) Select Install/Remove (for Version 4.0).
c) Select Device Driver Install and click on the Install...
button.
Chapter 7. Installing Software 113