IBM ThinkPad 380 - IBM Power Cords

Adding to the CONFIG.SYS File
Using an ATA card and a Flash card:
:
BASEDEV=PCM2ATA.ADD /!DM (ATA card device driver)
DEVICE=C:\THINKPAD\FLSH2MTD.SYS
(↑ Flash Card Memory Technology driver)
DEVICE=C:\THINKPAD\PCMSSDIF.SYS
(↑ Storage API device driver)
DEVICE=C:\THINKPAD\PCM2FLSH.SYS
:(↑ Flash card device driver)
BASEDEV=OS2PCARD.DMD (Storage Card Device Manager)
Using an ATA card, an SRAM card, and a Flash card:
:
BASEDEV=PCM2ATA.ADD /!DM (ATA card device driver)
DEVICE=C:\THINKPAD\FLSH2MTD.SYS
(↑ Flash Card Memory Technology driver)
DEVICE=C:\THINKPAD\PCMSSDIF.SYS
(↑ Storage API device driver)
DEVICE=C:\THINKPAD\PCM2SRAM.SYS
(↑ SRAM card device driver)
DEVICE=C:\THINKPAD\PCM2FLSH.SYS
:(↑ Flash card device driver)
BASEDEV=OS2PCARD.DMD (Storage Card Device Manager)
Rule 5 The Storage Card Device Manager (OS2PCARD.DMD)
must be added after the Power Management Support
driver ($ICPMOS2.SYS) in the CONFIG.SYS file. If you
don't have the Power Management Support driver, the
Storage Card Device Manager must be added at the end
of the CONFIG.SYS file.
Appendix B. Advanced Information for PC Cards for OS/2 Warp 187