Using PS2 Commands
Note:
Create the hibernation file using the
HFILE command before using this
command.
Enter hibernation mode when the power switch is pressed:
HSWITCH Enable | Disable
Set the timer to enter hibernation mode after the specified number of
minutes (
xx
):
HTimer
xx
[AC | DC]
Note:
Create the hibernation file using the
HFILE command before using the LB
H command.
Set the power management mode to enter when a low-battery condition
occurs:
AC: Specifies battery mode when the AC Adapter is connected.
DC: Specifies ac mode when using battery power:
LBattery Suspend | Hibernation —
Note:
This command is effective on the
current power mode set by the PM
command.
Set the LCD off when there is no computer operation after the specified
number of minutes (
xx
):
LCd
xx
—
Note:
yyyy
can be set from 1995 to 2093.
Set the resume timer:
Set the power mode:
ON at [yyyy/MM/DD] HH:MM:SS
| Clear
—
PMode High | Auto | Custom [AC | DC]
Note:
When the AC or DC option is not
specified, this command is effective
on the current power mode set by
the PM command.
Set the timer to enter suspend mode after the specified number of minutes
(
xx
):
AC: Specifies battery mode when the AC Adapter is connected.
DC: Specifies ac mode when using battery power.
POwer
xx
[AC | DC]
Resume normal operation when detecting an incoming call:
RI Enable | Disable —
Appendix C. Using PS2 Commands 197
To Next Page
Loading...
