IBM ThinkPad 380 - Page 218

Using PS2 Commands
Enter RediSafe suspend mode:
SAfe Enable | Disable —
Set power on or off for the serial device attached to the serial port:
SErial ON | OFf —
Note:
When the AC or DC option is not
specified, this command is effective
on the current power mode set by
the PM commands.
Set the processor speed:
AC: Specifies battery mode when the AC Adapter is connected.
DC: Specifies ac mode when using battery power.
Parameter1 Parameter2 Parameter3 Parameter4
SPeed Fixed | Auto MAX | Medium |
Slow | MIN
[AC | DC]
Set the timer to enter hibernation mode from suspend mode after the
specified number of minutes:
Parameter1 Parameter2 Parameter3
S2H 30 | 60 | 90 | Disable —
Set the timer to enter standby mode after the specified number of minutes
( xx ):
AC: Specifies battery mode when the AC Adapter is connected.
DC: Specifies ac mode when using battery power.
STandby xx [AC | DC]
Note:
Create the hibernation file using the
HFILE command before using the TI
H command.
Set the power management mode to enter by the automatic power-saving
timer:
TImer Suspend | Hibernation —
198 IBM ThinkPad 380 or 380D User's Guide