Using Easy-Setup
Date/Time
Date/Time is used to set the current date and time.
Select any field (Year, Month, Date, Hour, Minute, or Second) with
the Arrow keys or pointing device; then type or click on the or
icon to change the setting. Clicking on the or icon
changes the setting more quickly.
After verifying the selection, click on OK or press Enter. To cancel
the setting, click on Cancel or press Esc.
Password
Password is used to set the power-on password and the hard disk
password.
For more information about the power-on password and the hard
disk password, see Chapter 5.
123
Startup
Start up is used to change the startup sequence of your computer.
Following panel shows default start up.
For more information about the startup sequence, see “Using the
Selectable Drive-Startup Sequence” on page 37.
Chapter 3. Operating Your Computer 35
To Next Page
Loading...
