ThinkPad 390/i Series 1700
Hardware Maintenance Manual
About This Manual
This manual contains service and reference information for
the IBM ThinkPad 390/i Series 1700 products. Use this
manual along with the advanced diagnostics tests to trou-
bleshoot problems effectively.
The manual is divided into sections as follows:
The introduction section provides general information,
guidelines, and safety information required to service
computers.
The product-specific section includes service, refer-
ence, and product-specific parts information.
This manual is intended for trained servicers who are
familiar with ThinkPad products. Use this manual along
with the advanced diagnostics tests to troubleshoot prob-
lems effectively.
Read This First
Before you go to the checkout guide, be sure to read this
section.
Important Notes
Only certified trained personnel should service
the computer.
Read the entire FRU service procedures before
replacing any FRUs.
Use new nylon-coated screws when you replace
FRUs.
Be extremely careful during write operations such
as copying, saving, or formatting. Drives in the
computer that you are servicing might have been
rearranged or the drive startup sequence might have
been altered. If you select an incorrect drive, data or
programs might be overwritten.
Replace FRUs only for the correct model. When
you replace a FRU, make sure the model of the
machine and FRU part number are correct by refer-
ring to the FRU parts list.
A FRU should not be replaced because of a
single, unreproducible failure. Single failures can
occur for a variety of reasons that have nothing to do
with a hardware defect, such as: cosmic radiation,
electrostatic discharge, or software errors. FRU
replacement should be considered only when a recur-
ring problem exists. If this is suspected, clear the
ThinkPad 390/i Series 1700
19
To Next Page
Loading...
Need help?
General