2
When you are prompted to insert Disk 1, use the new diskette
created in step 1.
3
When you are prompted to insert Disk 2, use the new diskette
created in step 1.
4
Go to the next section to install OS/2 Warp Version 4.
Installing OS/2
Your installation of OS/2 depends on whether you use the
Dual Boot
or the
Boot Manager
for switching between OS/2 and DOS/Windows
3.1.
If you use the Dual Boot, go to the next step.
If you use the Boot Manager, install the Boot Manager first.
Then go to the next step. (Refer to the OS/2 documentation for
information on installing Boot Manager.)
1
Install DOS, Windows, and the ThinkPad Configuration program
before installing OS/2.
2
Install OS/2 by referring to the OS/2 documentation.
Pay attention to the following when you install OS/2:
In the “System Configuration” window, click on VGA as the
Primary Display.
In the “System Configuration” window, click on No Support
Installed at PCMCIA Feature.
(For using the CD-ROM drive:) In the “System
Configuration” window, click on Non-Listed IDE CD-ROM
or IDE CD-ROM.
Notes:
1. To install the ThinkPad Configuration for DOS
Installing the
ThinkPad Configuration Program for DOS .
2. To install the ThinkPad Configuration for Windows 3.1
Installing the
ThinkPad Configuration Program for Windows 3.1 .
150 IBM ThinkPad 600E Online Book
To Next Page
Loading...
