Diagnosing problems
If you have a problem with your computer, you can test it by using
PC-Doctor
®
for Windows
®
. To run PC-Doctor for Windows, do as follows:
1. Click Start.
2. Move the cursor to All Programs (in Windows other than Windows
®
XP,
Programs) and then to PC-Doctor for Windows.
3. Click PC-Doctor.
4. Choose one of test, from either the Device Categories or the Test Scripts.
Attention
Running any tests may take up to several minutes or longer. Make sure
you have time to run the entire test; do not interrupt the test while it is
running.
The System Test of the Test Scripts runs some tests of critical hardware
components, but it does not run all of the diagnostic tests in PC-Doctor for
Windows. If PC-Doctor for Windows reports that all of the tests in the System
Test have been run and that it has found no problems, consider running more
of the tests in PC-Doctor for Windows.
If you are preparing to contact IBM for support, be sure to print the test log
so that you can rapidly provide information to the help technician.
Solving computer problems
12
ThinkPad
®
R40 Series Service and Troubleshooting Guide
To Next Page
Loading...
Need help?
General