6. When the Product Recovery program finishes, your computer will restart
and begin the configuration process.
To create a Recovery Repair diskette
If the F11 recovery option is not present you can use the Recovery Repair
diskette to enable the F11 Product Recovery option.
To make a Recovery Repair diskette, do the following:
1. Shut down and restart your computer.
2. At the prompt, press F11. (The option to press F11 appears for only a few
seconds. You must press F11 quickly.) The Product Recovery program
main menu opens.
3. Select System Utilities from the main menu. Press Enter.
4. Select Create a Recovery Repair diskette. Press Enter.
5. Follow the on-screen instructions.
6. When the process is completed, label your diskette as the Recovery Repair
diskette and save it for future use.
To use the Recovery Repair diskette:
1. Shut down and turn off your computer.
2. Insert the Recovery Repair diskette into the drive; then turn on the
computer.
3. Follow the on-screen instructions.
Solving computer problems
Chapter 2. Solving computer problems 29
To Next Page
Loading...
