Removing a simple-swap hard disk drive
Attention: Simple-swap hard disk drives are not hot-swappable. Disconnect all
power from the server before removing or installing a simple-swap hard disk drive.
To remove a simple-swap hard disk drive, complete the following steps.
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 95.
2. Turn off the server and all attached devices; then, disconnect all power cords
and external cables.
3. Unlock the side cover.
4. Remove the side cover (see “Removing the side cover” on page 100).
5. Remove the bezel (see “Removing the bezel” on page 98).
6. Pull the loops of the drive assembly that is to be removed toward each other;
then, pull the assembly out of the bay.
7. If you are instructed to return the drive assembly, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to
you.
114 System x3400 Types 7973, 7974, 7975, and 7976: Problem Determination and Service Guide
To Next Page
Loading...
