Installing the hot-swap power-supply cage assembly
To install the hot-swap power-supply cage assembly, complete the following steps.
1. Align the screw holes on the power-supply cage pivot bracket with the
corresponding screw holes on the rear of the chassis. Support the cage while
you install the three screws to secure the pivot bracket on the power-supply
cage to the chassis.
Power supply
assembly
Power supply
retaining screws
2. Press the power-supply cage release tab and rotate the power-supply cage
assembly into the chassis until it locks in place.
Chapter 4. Removing and replacing server components 145
To Next Page
Loading...
