Important: Be careful when you handle the microprocessor and heat sink.
If the microprocessor and heat sink will be reused, do not contaminate the
thermal material between them.
b. Tip the top of the heat sink toward the front of the server while you slide it
away from the lower flange of the retention module; then, remove it from
the server. After removal, place the heat sink on its side on a clean, flat
surface.
Heat-sink locking
lever
Heat-sink
Microprocessor
10. Release the microprocessor release lever by pressing down on the end,
moving it to the side, and slowly releasing it to the open (up) position.
Microprocessor
release lever
(fully open)
Microprocessor
bracket frame
11. Open the microprocessor bracket frame by lifting up the tab on the top edge.
12. Carefully lift the microprocessor straight up and out of the socket, and place it
on a static-protective surface.
13. If you are instructed to return the microprocessor and heat sink, follow all
packaging instructions, and use any packaging materials for shipping that are
supplied to you.
156 System x3400 Types 7973, 7974, 7975, and 7976: Problem Determination and Service Guide
To Next Page
Loading...
