IBM Asia Pacific Hardware Announcement AG11-0009 IBM is a registered trademark of International Business Machines Corporation
25
Customer Replaceable Unit (CRU) Service
IBM provides a replacement CRU to you for you to install. CRU information and
replacement instructions are shipped with your machine and are available from
IBM at any time on your request. A CRU is designated as being either a Tier 1
(mandatory) or a Tier 2 (optional) CRU. Installation of Tier 1 CRUs, as specified
in this announcement, is your responsibility. If IBM installs a Tier 1 CRU at your
request, you will be charged for the installation. You may install a Tier 2 CRU
yourself or request IBM to install it, at no additional charge, under the type of
warranty service specified below, On-site Service.
Based upon availability, a CRU will be shipped for next-business-day (NBD) delivery.
IBM specifies in the materials shipped with a replacement CRU whether a defective
CRU must be returned to IBM. When return is required, return instructions and a
container are shipped with the replacement CRU, and you may be charged for the
replacement CRU if IBM does not receive the defective CRU within 15 days of your
receipt of the replacement.
The following parts are designated as CRUs:
• System foot kit (rear)
• System foot kit (front)
• Blank filler
• EMC shield kit
• SS EMC plate kit
• EMC shield 4x3.5
• 3.5-inch HS EMC kit
• Cable bracket asm
• Hard disk drive
• Hot-swap fan cage asm
• Hot-swap power supply
• Fan cage/guide arm asm
• Lift handle kit
• Opt wheel USB
• Cover Top/side
• Side cover asm
• Bottom cover
• Front bezel asm
• 120 mm Fan aasm
• DDR3-1333 Memory
• Memory expansion card
• Optical drive
• PCI adapter
• PCI divider
• Power cord
• CMOS battery
• Service label
• Service processor
• Rack bezel asm
• Air duct
• Key card asm
• W2008 CDs
• Keyboards
To Next Page
Loading...
Need help?
General