Need help?Do you have a question about the iCarsoft VOL V3.0 and is the answer not in the manual?
Explains Basic Settings for parameter resets and Adaptation for learning/calibration of control modules.
Guides users on reading fault codes, viewing their status, and accessing frozen frame data for diagnostic analysis.
Explains the procedure for bleeding the ABS brake system to restore sensitivity after component replacement or fluid loss.
Details the steps for performing an oil reset, including setting distance or days since last oil change.
Guides on inputting the required mileage after an oil change for the oil reset function.
Explains how to input the number of days since the last oil change for the reset procedure.
Describes the EPB system maintenance, including deactivation and reactivation for replacement and initialization.
Provides detailed steps for EPB calibration, including engaging the parking brake, operating the clutch, and confirming calibration.
Explains how to register a new battery to the BMS and reset internal battery monitoring data after replacement.
Details the process for forced DPF regeneration to clear blockages and turn off the DPF indicator.
Guides users through driving conditions and steps required for a successful DPF forced dynamic regeneration.
Describes the SAS calibration process to align the steering wheel and recalibrate the sensor after part replacement.
Explains how to relearn the throttle valve stop point value after clearing or replacing the throttle valve.
Details the ABS bleeding function to remove air and restore brake sensitivity after component replacement or fluid issues.
Provides step-by-step instructions for performing the ABS brake bleeding procedure, including pedal operation and screw adjustments.
Explains how to write or rewrite injector configuration values for correct fuel injection after renewal or replacement.
Guides on selecting the injector, entering identification numbers, and ensuring correct fuel injector operation.
Details the process for TPMS sensor replacement, including inputting sensor IDs and performing road tests.
Explains how to identify TPMS sensors, input identification numbers, and conduct road tests for confirmation.
Explains how to activate a replaced fuel pump to ensure proper fuel injection and engine running state.
Explains learning and calibration for body stability control units and related sensors like BAS and ESP.
Lists the 10 modes of OBDII/EOBD supported by the tool, including reading codes, live data, and readiness tests.
Guides on using the DTC lookup function to find definitions of diagnostic trouble codes.
Details the steps for downloading and installing software updates for the diagnostic tool via a PC.
General| Connectivity | USB |
|---|---|
| Vehicle Coverage | Volvo, Saab |
| Operating Current | 150mA@12V (Typical) |
| Coverage | Volvo, Saab |
| Display | 480*320 Pixels |
| Languages | English, German, Dutch, Spanish, French |
| Screen | 4.0 inch TFT LCD |
| Operating Temperature | 0°C to 50°C |
| Storage Temperature | -20°C to 70°C |
| Power | 8V-18V |
| Power Consumption | 1.8W |
| Functions | Service Reset |
| Update Method | USB |
| Power Supply | Vehicle Battery |
| Connector | OBDII |
To Next Page