Loosen the harness by pressing the harness adjustor button
while pulling the shoulder straps forward as far as possible (G-1).
Seperate the backrest from the base by turning and removing
the jointshaft from the joint between the base and the backrest
(G-2). Unhook the shoulder harness from the metal hooks which
sits between the backrest and base (G-3).
Take o the cover of the headrest, unscrew the cap at the back
of the headrest (see fig. G-4) Then uninstall the slide and harness
shoulder belt shaft (G-5).
The headrest can now extend futher.
14
To Next Page
Loading...
