Need help?Do you have a question about the ICMA S303 and is the answer not in the manual?
General| Supply Voltage | 24 VDC |
|---|---|
| Operating Temperature | -20°C to +60°C |
| Digital Inputs | 8 |
| Analog Inputs | 4 |
| Analog Outputs | 2 |
| Enclosure | IP20 |
| Mounting | DIN Rail |
| Processor | ARM Cortex-M4 |
| Flash Memory | 512 KB |
| Operating Voltage | 24 VDC |
| Communication Interface | Ethernet, RS-485 |
| Protocols | Modbus TCP, Modbus RTU |
| Communication Interfaces | Ethernet, RS-485 |
Lists optional accessories and spare parts for the control unit.
Details technical specifications like power supply, sensors, operating range, and dimensions.
Instructions for powering the control unit on and off using the 'esc' key.
Explains how the display backlight is activated and its auto-off function.
Describes the internal buzzer for user feedback and its disable option.
Details the test to verify functionality of connected loads and outputs.
How the unit displays measured temperatures and pump speeds.
Explains the two operating modes: Automatic and ABC control.
Guide on how to enter the correct password to access installer parameters.
Steps to change the existing password for installer access.
Allows setting thermal data like safety temperatures, differentials, and hysteresis.
Configuration of parameters related to the antifrost function.
Enables or disables acoustic signals like keyboard tones and alarms.
Allows reversing the output logic for relays, specifically OUT 2.
Displays or resets the operating hours of the integrative source.
Manages the Minimum Temperature Thermostat for collector pump activation.
Adjusts settings for pump control via PWM or 0-10V output.
Sets the 'T SF' temperature for collector pump reset to avoid thermal shock.
Configures operating programs for systems with vacuum tubes, prioritizing safety.
Enables or disables the Anti-legionella function for boiler water heating cycles.
Explains the logic behind the 'ABC' function and its impact on differential control.
Describes how safety thermostats function and trigger alarm relays.
Details the conditions under which the alarm relay is activated based on temperature readings.
Solar heating installation with 1 tank and no integrative heat source.
Solar heating installation with 1 tank and additional thermostatic heating.
Pool solar heating installation diagram.
Solar heating installation with 1 tank, direct integration by valve logic.
Natural circulation solar heating installation with 1 tank and direct integration.
Solar heating installation with 1 tank and only 2 probes.
Allows the user to enable or disable the Anti-legionella function.
Provides functionality to reset alarms or the 30-day counter.
Access to specific user parameters like max temperatures and antifrost settings.
To Next Page