7
3
PREPARATION
■ Entering the MMSI code
The Maritime Mobile Service Identity (MMSI: DSC self ID) code consists of 9 digits.
You can only enter the code when turning ON the transceiver for the rst time.
This initial code can be entered only once.
After entering, it can be changed only by your dealer or distributor.
If your MMSI code has already been entered, doing the steps below is not necessary.
1. Hold down [PWR] to turn ON the transceiver.
• Three short beeps sound, and “Push [ENT] to
Register your MMSI” is displayed.
2. Push [ENT] to start entering the MMSI code.
• The “MMSI INPUT” screen is displayed.
L Push [CLEAR] twice to skip the entry.
If you skip the entry, you cannot make a
DSC call. To enter the code after skipping,
turn OFF the power, and then turn it ON
again.
3. Enter the MMSI code.
TIP:
• Select a number using [◄] and [►].
• Push [ENT] to enter the selected number.
• Select “←” or “→” on the screen, or rotate
[DIAL] to move the cursor.
4. Repeat step 3 to enter all 9 digits.
5. Select
and push [ENT] to set the
entered code.
• The “MMSI CONFIRMATION” screen is
displayed.
6. Enter your MMSI code again to confirm.
7. Select
to set the entered code.
• When your MMSI code is successfully
entered, “MMSI registered successfully.”
is briey displayed, and then enters the
operating screen.
L Your MMSI code is also displayed on the
opening screen.
For only the EUR version:
When you turn ON the transceiver, “Model” screen is displayed depending on the
setting. Select the country where you operate the transceiver.
FELLECS-TECH | inbox@fellecs-tech.com | www.fellecs-tech.com
To Next Page
Loading...
