Icom IC-M410BB - Page 76

63
8
AIS FUNCTION
■ AIS settings
ID Blocking
The transceiver blocks AIS transponders
that are entered into the ID Blocking list.
Enter your vessel’s transponder ID or other
vessel’s transponder IDs if necessary to
prevent the transceiver from detecting them
as dangerous targets.
L You can enter up to 10 MMSI codes.
• Entering an ID
1. Open the “ID BLOCKING” screen.
[MENU] > Settings > AIS > ID Blocking
• The blocked AIS transponder’s ID is
displayed.
• “No ID” is displayed if there is no
blocked AIS transponder.
2. Push to start the ID entry.
3. Enter an ID.
TIP:
• Select a number using [◄] and [►].
• Push [ENT] or [DIAL] to enter the
selected number.
• Select “←” or “→,” or rotate [DIAL]
to move the cursor.
4. Select , and then push [ENT]
to enter the ID.
• Editing an ID
1. Open the “ID BLOCKING” screen.
[MENU] > Settings > AIS > ID Blocking
2. Push [▲] or [▼] to select an ID.
3. Push
.
• See step 3 in “Entering an ID,” as
described above.
4. Push .
• Deleting an ID
1. Open the “ID BLOCKING” screen.
[MENU] > Settings > AIS > ID Blocking
2. Push [▲] or [▼] to select an ID.
3. Push
.
• “Delete the ID. Are you sure?” is
displayed.
4. Push .
FELLECS-TECH | inbox@fellecs-tech.com | www.fellecs-tech.com