Icom IC-M410BB - Page 98

85
11
CONNECTIONS
■ Microphone installation
When you use the supplied or optional HM-195 , the optional

and the transceiver to operate from even longer distances.

NOTE:
them to the transceiver.
D Installation
1. 
tighten the nut.
2. 
3. 

 Drill holes at these marks.
5. 
6. The completed installation should look like this.

Nut
Cap
Gasket
Screw holes
(Approximately 2 (d) mm,
1/16 inch)
FELLECS-TECH | inbox@fellecs-tech.com | www.fellecs-tech.com