- 46 -
1. To remove the Grille from the Chassis
• Set the up-and-down air discharge louver to open
position (horizontally) by finger pressure.
• Remove the securing screws at the bottom of
grille.
• To remove the Grille, pull the lower left and right
side of the grille toward you (Slightly titled) and
lift it straight upward.
2. To remove the Control Box
• Remove the thermisters. One from thermistor
holder on evaporator, the other from pipe holder.
• Remove step motor connector, motor connector from
main P. C. B.
• If necessary, disconnect DC power supply cord
from pillar terminal, and remove the clip screw.
(Be careful not to lose the clip when reassem-
bling)
- 46 -
Grille
Chassis
Screw (3places)
Thermistors
DC power supply cord
(Connecting Cable)
Pillar terminal
Clip
Connectors
Hazardous voltage can cause ELECTRIC SHOCK or
DEATH. Turn off circuit breaker before you start
checking or servicing.
WARNING
(2) 18K, 24K Models(Cooling Only, Cooling & Heting)
To Next Page
Loading...