Need help?Do you have a question about the ICP PHF Series and is the answer not in the manual?
Overview of single package heat pumps, including series and phase.
Defines and explains the usage of danger, warning, caution, and signal words.
Guidance on unit placement, including clearances and access panels.
Details on installation requirements, including ground level platforms.
Procedures for lifting and securing the unit for rooftop installation.
Steps to adapt the unit for downflow airflow configurations.
Essential safety warnings, grounding, and adherence to electrical codes.
Wiring diagrams and instructions for thermostat and low voltage connections.
Procedures for grounding and line voltage connections with safety notes.
Guidance on typical wiring installation and final electrical checks.
Information on ductwork design, connections, and mandatory filter usage.
Instructions for determining and setting the blower motor speed.
Details on how the unit operates in cooling, heating, and defrost modes.
Explanation of defrost mode activation, delays, and testing.
Procedure to adjust the defrost time interval on the control board.
Instructions for operating in cooling mode and turning the unit off.
Guidance on maintaining air filters, condenser coil, and condensate drain.
Location and use of access ports for refrigeration system servicing.
Instructions for oiling the condenser fan motor bearings.
Procedure for accessing and oiling the blower motor bearings.
Overview of warranty coverage, limitations, and exclusions for products.
Specific warranty terms for residential central gas/oil furnaces and heat exchangers.
Warranty terms for commercial applications, including 3-phase models and heat exchangers.
To Next Page
General