To Next PageTo Next Page
Need help?Do you have a question about the ICP PHX348000K00A1 and is the answer not in the manual?
Lists critical safety points for installation and maintenance.
Provides a brief overview of the PHX3 unit and its design.
Refers to Figure 1 for unit access panel locations.
Details minimum required clearances around the unit for operation and service.
Details platform requirements for ground installations.
Details platform requirements for rooftop installations.
Instructions for safely lifting and moving the unit.
Steps to convert the unit for downflow air discharge.
Requirements for the field-supplied disconnect switch.
Instructions for making the unit's ground connection.
Guidance on thermostat and low voltage wiring.
Covers sizing, insulation, and connection requirements for ductwork.
Table listing recommended filter sizes for PHX3 units.
Table detailing blower speeds and air delivery at various static pressures.
Instructions for verifying and setting blower motor speeds for heating and cooling.
Pre-start checks including filters and access panels.
Describes sequences for cooling, heating modes, and defrost cycle.
Explains the compressor recycle delay timer function.
Routine monthly checks for air filters and condenser coil.
Annual inspection tasks including fan motor and blower motor checks.
Detailed instructions and warnings for safe rigging and lifting.
Schematic diagram illustrating electrical connections for the unit.
General